| Fiberglass Self-adhesive Mesh Tape |
| |
INTRODUCTION
Fiberglass self-adhesive mesh tape is widely used in covering drywall joints, cracks, and holes on drywalls, plasterboard, stucco and other surface.
It has property of easy to apply, no pre-plastering required, more environmentally-friendly job. It will not tear, shrink, stretch or bubble, while it hides joints, cracks and holes permanently.
 
SPECIFICATION
|
Product Code |
Yarn Tex（TEX） |
Density |
Area Weight |
Resin Content |
Tensile Strength |
|
(Counts/25mm) |
G/M2 |
% |
N/50MM |
|
Warp |
Weft |
Warp |
Weft |
|
|
Warp |
Weft |
|
CNT80-9X9 |
33X2 |
99 |
9±0.5 |
9±0.5 |
80 |
≥28 |
≥600 |
≥800 |
|
CNT73-9X9 |
50x2 |
50 |
9±0.5 |
9±0.5 |
73 |
≥28 |
≥800 |
≥500 |
|
CNT65-9X9 |
33X2 |
66 |
9±0.5 |
9±0.5 |
65 |
≥28 |
≥600 |
≥550 |
|
CNT65-8X8 |
50X2 |
50 |
8±0.5 |
8±0.5 |
65 |
≥28 |
≥700 |
≥450 |
|
CNT60-8X8 |
33X2 |
66 |
8±0.5 |
8±0.5 |
60 |
≥28 |
≥500 |
≥500 |
|
CNT50-8X8 |
33X2 |
50 |
8±0.5 |
8±0.5 |
50 |
≥28 |
≥500 |
≥450 |
 
APPLICATION PROCEDURE
Wall must be clean and dry;
Center and apply tape over the length of the joint and pressing firmly;
Apply a generous first coat of compound over the tape and through the mesh, making sure to completely fill the joint crevice. When the joint has been completely filled, wipe off any excess compound with the drywall knife leaving enough to cover the tape;
Let dry completely, then sand slightly;
Apply sufficient thin finishing coats to produce a smooth wall surface;
Cut of butted boards do not have a tapered edge. Therefore, special care must be taken to assure proper compound penetration of all joints. This may result in slight build-up of compound that will require an increased amount of edge feathering.
PACKING：
Width (mm): 25mm, 35mm, 50mm, 75mm, 100mm, 150mm, 200mm, 300mm, 1000mm, etc.
Length (m): 10m, 20m, 45m, 90m, 153m
Each roll is shrink-wrapped, or to be packed in plastic bag. Then rolls are packed into carton.
|
|
